time ranger feature can u explain

[Cumberland County]

Hi the time ranger offers a sensitivity plus or minus feature,

if anyone has this model I would appreciate when you mostly use this feature and info about it.

another question about the "all metal" does sensitivity feature aply here.

seems like when i hit the all metal mode IM pretty much going off as it gets within a couple inches of the ground, I try to ground balance b4 I start.

Secondly IM assuming anytime I shut the machine off my ground balance has been cancelled and must be redone when I restart the machine.

[osros]

Originally Posted by Cumberland County

Hi the time ranger offers a sensitivity plus or minus feature,

if anyone has this model I would appreciate when you mostly use this feature and info about it.

another question about the "all metal" does sensitivity feature aply here.

seems like when i hit the all metal mode IM pretty much going off as it gets within a couple inches of the ground, I try to ground balance b4 I start.

Secondly IM assuming anytime I shut the machine off my ground balance has been cancelled and must be redone when I restart the machine.

I dont have a Time Ranger, wish I did. But if the same applies for the BH SSII controls I have not noticed a change in sensitivity when in all metal mode, if there is its hard to tell for me.

On Ground balance I try to find a quiet spot then hit the ground balance which sets it, it will go off giving you a constant tone or no tones so then you need to ground balance again.

Yes always ground balance when you start the machine. I balance from time to time if Im not sure about a signal and I what to eliminate the machine not set right as the problem.

Hopes that helps.