CTX-3030 Program

SkateCreek

Well-Known Member
#1
Anyone else using a CTX? Wanna share some programming?

Here is a program that I have had excellent success with,
it is Combined, with ferrous-coin seperation.... upload to
your CTX and give it a shot.
(see attached .mlf file)

If you do try it and have any feedback I would appreciate
to hear what you think, good or bad.

This program is as follows:
Response: Smooth
Recovery: Fast
Target seperation: Ferrous-coin
Pinpoint type: Sizing
Tone ID: Combined - 4 Tone

I have found this program to be excellent with jewelry
and US Coins.

Thanks

SK8
 

Attachments

JohnC

Well-Known Member
#3
I like pinpoint type sizing! Many times I can tell that my pinpoint (Safari) tell me the size is too big for coin!
 

River Styx

Active Member
#8
Anyone else using a CTX? Wanna share some programming?

Here is a program that I have had excellent success with,
it is Combined, with ferrous-coin seperation.... upload to
your CTX and give it a shot.
(see attached .mlf file)

If you do try it and have any feedback I would appreciate
to hear what you think, good or bad.

This program is as follows:
Response: Smooth
Recovery: Fast
Target seperation: Ferrous-coin
Pinpoint type: Sizing
Tone ID: Combined - 4 Tone

I have found this program to be excellent with jewelry
and US Coins.

Thanks

SK8
I will give it a shot, thanks. I had those problems today.
 

River Styx

Active Member
#9
New to the machine, been reading but does anyone know how to read his file or upload it to the machine? I have it plugged to the the lap top now but don't see where to upload the new mode from a file.

I see the file upload section and a new mode section, my point is cant get it to read or take his. What am I missing here?