Keep your eyes out on screws that stripe out of the plastic head on the V3.

[Eagle 1]

I don't know how long this is been like this but. I have one screw that is striped out of the plastic. You don't notice it by looking at it. I was changing my coil and rapping the coil wire around the rod. I grabbed one of the edge of the black plastic control head and it felt because of the soft rubber center. It should be tight and not spongy fealing. It is 2 peace of plastic held by 4 scews. I could see I could pull the corner open a bit. I went to get my Allen to tighten it up and the screw would not grab. I had to find out if it was striped. I will have to send it in too Whites for a fix and up grade. I remember someone that had problem with this about 6 mo. ago. I have about 5 or 6 weeks left to hunt and I will send it after that.

Eagle 1

[Ric-san]

Wow, hadn't heard of that one yet...

[Eagle 1]

Originally Posted by Ric-san

Wow, hadn't heard of that one yet...

It seem to be only on the first gen. MDs. Visions.

Eagle 1

PS I love your punkin real cool.

[EBCIII]

I am sure White's will get you fixed right up. They really seem to take care of their customers, Beale.

[trigger]

I purchased a new v3 and out of the box I hadn't noticed the same "pull through". After contacting the dealer he advised me that he had seen 1 before with the same issue. It is with the early versions of the v3 and something with the plastic composition. Without hesitation a brand new complete v3 was given with any hassle. Just bring it back and a new one will be given. Whites knows about the problem.

Hope this asures you

Cheers

[rcasi44]

There should be no newer V3's with this problem. Carl said it has been addressed. Rob