dfx program

[skinnybones]

does anyone have a personalized program for the dfx using a 14"DD excelerator coil, i'm using deep silver program with some success but am looking to tweak more from it. would really appreciate some input. thanks

[The TINMAN]

Hi Skinnybones Don't have a program BUT I did have a DFX & if you go to the DFX Only forum you'll get plenty of them there . Lots of good folks there. Hope this helps.

The TINMAN

[smudger]

taken from historyhunters site in the uk,,,, hope it helps


Target Vol--63
Audio Threshold--0 this is important
Tone--190 this also is important as this is the tone you will hear iron at.
Audio Disc --ON
Silent Search--Off
Mixed Mode--ON
Ac Sens-- Set for the site (stable threshold then turn threshold off)
DC sens-- 25 this dictates the iron sound
back light --OFF
viewing Angle --30
Rachet P/Point ON-Important as you don't use VCO
Sat Speed--5
Tone ID--OFF
VCO --OFF Impotarnt
Modulation--OFF
autotrac--On
Trac View ON until set
Track Speed ??
Track Offset 0 or +1
Track Inhib--ON

Block Edit -- Reject -95 to +5 accept +6 to +94 reject +95 as you are in all metal you will hear all signals but anything below +5 and +95 (iron will give a low tone and hot rocks a broken sound with low tone coming in.

Learn R --OFF
Learn A --OFF
Recovery Speed 30
B/Cap Reject 1
H/Rock Rej--0 as you have rejected +95
Sweep Speed 6
Filters 6 but depends on the site
Visual Disc --ON
Icons --OFF
VDI Sens 85
DC Phase --ON
graph Ave & Acc --ON
Fade rate 8
Pre-amp 3 if your sitting at AC 75 and its stable then try upping this but not VDI normalised ON
15 KH

The aim of this mode is to give LOW tones for iron and HIGH tones for anything accepted. You very rarely hear the iron. If set too high you will get false high tones. If you give this mode time you will not even look at the meter. I have used this with the DD coils on mineralised sites (94 and higher on the DC phase reading) and it is very good.